Why isn't water flowing after installing the Ultra Filter?Updated 2 hours ago

The Ultra Filter in the Klyqa Welly is made of a microporous material that must be primed (air removed) before first use. If air remains trapped inside the filter, it can completely block the water flow.

How to prime the Ultra Filter

1. Fill the fresh water tank halfway
   Add clean water until the tank is about half full.
2. Remove the air from the filter
   Place the Ultra Filter horizontally under the water and keep it submerged until no more air bubbles rise to the surface. This usually takes just a few seconds.
3. Install the filter
   Align the primed filter with the filter compartment and press it firmly into place until it is fully seated.
4. Complete the setup
   Fill the tank with water if needed, close the lid, and place the fresh water tank back onto the base.

Note:
If the filter has not been primed, the trapped air can completely block the water flow.

You only need to perform these steps when installing a new Ultra Filter for the first time or whenever you replace the filter.